Click here to close
Hello! We notice that you are using Internet Explorer, which is not supported by Xenbase and may cause the site to display incorrectly.
We suggest using a current version of Chrome,
FireFox, or Safari.
J Gen Physiol
2002 Oct 01;1204:509-16. doi: 10.1085/jgp.20028672.
Show Gene links
Show Anatomy links
Slow inactivation does not block the aqueous accessibility to the outer pore of voltage-gated Na channels.
Struyk AF
,
Cannon SC
.
???displayArticle.abstract???
Slow inactivation of voltage-gated Na channels is kinetically and structurally distinct from fast inactivation. Whereas structures that participate in fast inactivation are well described and include the cytoplasmic III-IV linker, the nature and location of the slow inactivation gating mechanism remains poorly understood. Several lines of evidence suggest that the pore regions (P-regions) are important contributors to slow inactivation gating. This has led to the proposal that a collapse of the pore impedes Na current during slow inactivation. We sought to determine whether such a slow inactivation-coupled conformational change could be detected in the outer pore. To accomplish this, we used a rapid perfusion technique to measure reaction rates between cysteine-substituted side chains lining the aqueous pore and the charged sulfhydryl-modifying reagent MTS-ET. A pattern of incrementally slower reaction rates was observed at substituted sites at increasing depth in the pore. We found no state-dependent change in modification rates of P-region residues located in all four domains, and thus no change in aqueous accessibility, between slow- and nonslow-inactivated states. In domains I and IV, it was possible to measure modification rates at residues adjacent to the narrow DEKA selectivity filter (Y401C and G1530C), and yet no change was observed in accessibility in either slow- or nonslow-inactivated states. We interpret these results as evidence that the outer mouth of the Na pore remains open while the channel is slow inactivated.
???displayArticle.pubmedLink???
12356853
???displayArticle.pmcLink???PMC2229532 ???displayArticle.link???J Gen Physiol ???displayArticle.grants???[+]
Figure 1. . Sites of informative cysteine substitution mutations in the outer pore. The SS2 segments are shown schematically in order of relative position from the DEKA Na ion selectivity region. Residues lettered in black represent sites at which cysteine substitution yielded informative data in state-dependent accessibility assays described below. Sites lettered in black outline denote locations at which we were not able to measure a modification rate of substituted cysteine residues. Residues in light gray were not tested, either because they were uninformative since they had no measurable effect when exposed to MTS-ET (D400, W756, K1237, and A1529), they did not produce a detectable INa (G1238), or the predicted modification rate was too slow for our assay (W1239).
Figure 2. . Introduction of cysteine missense mutations into informative P-region sites has little or no effect on the recovery kinetics of fast- or slow-inactivation. All measurements were made in excised outside-out macropatches held under perfusion with control bath solution. Conditioning pulses to â10 mV of 40 ms or 3 s duration were used to induce fast and slow inactivation, respectively, (A, inset). (A) Recovery from fast inactivation at â120 mV was unchanged between cysteine substitution mutants and wild-type. (B) Recovery from slow inactivation at â120 mV was not affected by introduction of cysteine residues at most informative sites. For E758C mutant channels, a modest acceleration in the time course of recovery was observed.
Figure 3. . The kinetics of entry to slow inactivation at â10 mV. The paired pulse protocol used to measure entry to slow inactivation is shown schematically at the top of the figure. The symbols used for each mutant are identical to those listed in the inset of Fig. 2 A. The majority of the mutations had no significant effect on the time course of entry to slow inactivation. E758C showed a modest 2.5-fold slowing in the time course of entry, and a modest decrease in the maximal extent of slow inactivation (Sâ). The shaded areas represent the timing and duration of the MTS-ET exposures designed to assay cysteine availability for predominantly fast- and slow-inactivated conditions.
Figure 4. . Measurement of state-dependent modification rate. (A) Na currents elicited by the assay pulses during serial exposures to MTS-ET are shown on a condensed time scale. The top number of the time scale represents the interval elapsed between each assay pulse, and the bottom number represents the time scale relative to individual assay pulses. In this example, accessibility of the E758C residue is being tested by serial 200 ms exposures to 2 mM MTS-ET early during the conditioning pulse (minimally slow inactivated). (B) Peak INa values from A are plotted against the cumulative time of exposure to MTS-ET, and fit with a single exponential decay. The apparent modification rate (RApparent) is then computed from the time constant.
Figure 5. . No state-dependent change of cysteine modification rate was seen in the six mutants studied. (A) Schematic representation of the pulsed MTS-ET application protocols. Modification rates for fast-inactivated channels were assayed by exposing outside-out patches to MTS-ET for 200 ms, beginning 20 ms into the 300 ms conditioning pulse (top protocol, open circles). To measure the modification rate of slow-inactivated channels, patches were exposed to MTS-ET beginning 10.5 s after the onset of a 12 s conditioning pulse (bottom protocol, filled circles). All conditioning pulses were to â10 mV, and a gap of 10 s at â120 mV to allow for full recovery from inactivation was inserted before a test pulse to â20 mV to measure remaining peak INa. This cycle was repeated until maximal modification in each patch had taken place. (B) Comparison of modification rates of cysteines in each of the four domains measured under conditions in which channels were predominantly fast- or slow-inactivated. The mean and SEM of these rates are plotted by domain location for each mutant, with rates for the two states of the channel connected by a line. The numerical values are listed in Table II.
Figure 6. . Absence of detectable modification of I757C by MTS-ET. Na currents elicited after successive exposures to 4 mM MTS-ET are shown on a compressed time scale. MTS-ET was applied for 200 ms, beginning 20 ms after the onset of a conditioning pulse to â10 mV (fast-inactivation protocol). No reduction in peak INa was detectable, even after a cumulative exposure time of 8 s. Onset of each trace is offset by the time interval between each trial (scale bar, top). Time scale during a trace is indicated by the number below the scale bar.
Balser,
External pore residue mediates slow inactivation in mu 1 rat skeletal muscle sodium channels.
1996, Pubmed,
Xenbase
Balser,
External pore residue mediates slow inactivation in mu 1 rat skeletal muscle sodium channels.
1996,
Pubmed
,
Xenbase
Bénitah,
Molecular dynamics of the sodium channel pore vary with gating: interactions between P-segment motions and inactivation.
1999,
Pubmed
,
Xenbase
Cannon,
Slow inactivation of sodium channels: more than just a laboratory curiosity.
1996,
Pubmed
Chiamvimonvat,
Depth asymmetries of the pore-lining segments of the Na+ channel revealed by cysteine mutagenesis.
1996,
Pubmed
,
Xenbase
Cummins,
Impaired slow inactivation in mutant sodium channels.
1996,
Pubmed
Featherstone,
Interaction between fast and slow inactivation in Skm1 sodium channels.
1996,
Pubmed
,
Xenbase
Hayward,
Defective slow inactivation of sodium channels contributes to familial periodic paralysis.
1999,
Pubmed
Jurkat-Rott,
Voltage-sensor sodium channel mutations cause hypokalemic periodic paralysis type 2 by enhanced inactivation and reduced current.
2000,
Pubmed
Karlin,
Substituted-cysteine accessibility method.
1998,
Pubmed
Kuzmenkin,
Enhanced inactivation and pH sensitivity of Na(+) channel mutations causing hypokalaemic periodic paralysis type II.
2002,
Pubmed
Liman,
Subunit stoichiometry of a mammalian K+ channel determined by construction of multimeric cDNAs.
1992,
Pubmed
,
Xenbase
Lipkind,
KcsA crystal structure as framework for a molecular model of the Na(+) channel pore.
2000,
Pubmed
Liu,
Dynamic rearrangement of the outer mouth of a K+ channel during gating.
1996,
Pubmed
McClatchey,
The cloning and expression of a sodium channel beta 1-subunit cDNA from human brain.
1993,
Pubmed
,
Xenbase
Ong,
A structural rearrangement in the sodium channel pore linked to slow inactivation and use dependence.
2000,
Pubmed
O'Reilly,
A point mutation in domain 4-segment 6 of the skeletal muscle sodium channel produces an atypical inactivation state.
2000,
Pubmed
O'Reilly,
Residue-specific effects on slow inactivation at V787 in D2-S6 of Na(v)1.4 sodium channels.
2001,
Pubmed
Pérez-García,
Structure of the sodium channel pore revealed by serial cysteine mutagenesis.
1996,
Pubmed
,
Xenbase
Rudy,
Slow inactivation of the sodium conductance in squid giant axons. Pronase resistance.
1978,
Pubmed
Struyk,
The human skeletal muscle Na channel mutation R669H associated with hypokalemic periodic paralysis enhances slow inactivation.
2000,
Pubmed
Takahashi,
Enhanced slow inactivation by V445M: a sodium channel mutation associated with myotonia.
1999,
Pubmed
Townsend,
Effect of alkali metal cations on slow inactivation of cardiac Na+ channels.
1997,
Pubmed
,
Xenbase
Vedantham,
Slow inactivation does not affect movement of the fast inactivation gate in voltage-gated Na+ channels.
1998,
Pubmed
,
Xenbase
Vedantham,
Rapid and slow voltage-dependent conformational changes in segment IVS6 of voltage-gated Na(+) channels.
2000,
Pubmed
,
Xenbase
Vilin,
A single residue differentiates between human cardiac and skeletal muscle Na+ channel slow inactivation.
2001,
Pubmed
,
Xenbase
Wang,
A mutation in segment I-S6 alters slow inactivation of sodium channels.
1997,
Pubmed