|
Figure 2. Macroscopic currents from cell-attached patch recordings of the various channel types. (A) Activation currents were induced by depolarizing pulses from a â100-mV holding potential to potentials of: â50 to 100 mV (SN); â80 to 100 mV (SNS); â80 to 30 mV (SNG); and â80 to 60 mV (SS); all in steps of 10 mV except 20 mV for SNS. The post pulse was â140 mV. (B) Tail currents were recorded at voltages of â70 to â150 mV (SN) and â110 to â170 mV (SNS, SNG, and SS) after prepulses to 40 mV (SN) or 0 mV (SNS, SNG, and SS). Potassium ion concentration was 140 mM on each side of the patch. Currents were filtered at 1 kHz. Note the different time scale for SN currents. (C) Representative G-V curves for each channel type, calculated from the macroscopic currents assuming a linear Iâ-V relationship. Superimposed on each curve is a fit of a Boltzmann function. The midpoint voltage V1/2 and effective charge q for each channel type were â41.7 ± 2.7 mV, 5.1 ± 1.1 e0 (SN, n = 3); â66.3 ± 3.4 mV, 7.5 ± 1.2 e0 (SNS, n = 6); â87.9 ± 1.9 mV, 9.2 ± 0.8 e0 (SNG, n = 3); â66.8 ± 2.8 mV, 10.7 ± 1.6 e0 (SS, n = 4). (D) Voltage dependence of the activation time constant Ïa, estimated by fits of an exponential function to the activation time course, starting from the time when the amplitude is 50% of the final value. (E) Voltage dependence of the activation delay time δa obtained in the same fits as the time at which the extrapolated exponential crosses the current baseline. (F) Voltage dependence of deactivation time constants Ïd estimated by single-exponential fits. The apparent charge q was 0.80 e0 (SN), 0.96 e0 (SNS), 0.84 e0 (SNG), and 0.83 e0 (SS), as estimated by fitting the last five data points (lines) with the exponential function Ï(V) = Ï(0)exp(qV/kT).
|
|
Figure 3. Single-channel currents from five channel types, recorded in inside-out patches. (A) Representative single-âchan-nel current traces of the SN channel and its derivatives. Potassium ion concentration was 140 mM on each side of the membrane. Channels were activated by a depolarization from a â100-mV holding potential to â60 mV (SN) or â70 mV (SNS and SNG). The tail potential was â140 mV (SN) or â120 mV (SNS and SNG). Note the different time scale for the SN current, which also has a larger single-channel conductance. Some dwells in subconductance levels are indicated by arrows. (B) Single-channel currents of Shaker and its derivative SS. Two selected sweeps recorded in symmetrical 140 mM K+ show the ânonburstingâ and âburstingâ behaviors of SS. The first sweep contains a brief dwell at a sublevel during activation (arrow) as well as a clear âstaircaseâ of conductances during deactivation. Also shown are five successive sweeps from a truncated Shaker B channel, recorded with 5 mM external K+. Some dwells at subconductance levels are indicated by arrows. For the recording from the NH2-terminalâtruncated Shaker B channel, the pipette solution contained 5 mM K-aspartate, 135 mM NMDG-aspartate, 1.8 mM CaCl2, and 10 mM Hepes. All recordings were filtered at 1 kHz. The recordings of SN and SS currents used uncoated patch pipettes, which yielded larger background noise.
|
|
Figure 4. First latencies of SN and SNS single-channel currents. (A and C) Representative traces at various depolarizations in single-channel patches from oocyte expressing SNS (A) or SN (C). The dotted line marks the beginning of the depolarizations. (B and D). The cumulative first-latency distributions are plotted for SNS (B) and SN (D) at the potentials indicated. First latencies were measured as the time to first opening, to either sub- or main conductance level.
|
|
Figure 5. Amplitudes of the three current levels in SNS channels. (A) Representative current trace showing channel activation at â70 mV and deactivation at â140 mV. Boxes indicate regions of this trace used in constructing the amplitude histograms. (B) Amplitude histograms of the single-âchannel current at the two voltages, accumulated from portions of 380 sweeps as in A. Filter bandwidth was 1 kHz. Superimposed are fits of three (â70 mV) or four (â140 mV) Gaussian functions; the midpoint of each Gaussian is taken to be the mean current amplitude. The standard deviations (in pA) of the Gaussian components are as follows. For â70 mV: 0.25 (closed), 0.36 (sub2), 0.25 (open); for â140 mV: 0.30 (closed), 1.0 (sub1), 0.54 (sub2), 0.50 (open). (C) The mean current amplitudes at different voltages. The superimposed linear fits yield the slope conductances shown.
|
|
Figure 6. Sublevels of the SNS single-channel current during activation. (A) Representative traces at â70 mV. Solid lines show channel closed and open levels; dashed lines (θ1, θ2, and θ3) are thresholds at 10, 50, and 85% of the open amplitude. In the upper trace, the channel spends t1 = 2.9 ms in the sub1 state and t2 = 3.9 ms in the sub2 state before reaching the open state. In the lower trace, the channel appears to open instantaneously into sub2, but a finite t1 is measured because of filtering. Filter bandwidth is 1 kHz. (B) Cumulative histogram of measured dwell times t1 in sub1 (solid curve) accumulated from 140 events. The dashed curve is the cumulative distribution from a simulation of 250 events with mean lifetime ÏSub1 and fraction fSub1 of nonzero dwells in sub1 as given. (C) A scheme for channel activation that accounts for the distributions of t1 and t2. Channels can open through two distinct pathways, allowing sub1 to be skipped but always traversing sub2. (D) Cumulative histogram of 140 dwell times at sublevel sub2. The dashed curve is from a simulation of 250 events with the given mean dwell time and fraction of nonzero dwells.
|
|
Figure 7. Examples of single-channel tail currents of SNS at â120 mV (A) and â140 mV (B). Solid lines show channel closed and open levels, while dashed lines indicate thresholds θ1, θ2, and θ3 at 10, 50, and 85% of the open level. Data filtered at 1 kHz. Below each trace is the idealized current time course.
|
|
Figure 8. Voltage dependence of mean dwell time in the open state and the two substates. Data points at each voltage represents the mean value, with the number of measurements marked in parentheses (except the data at â30 mV, which represents a single measurement). The curves are the values predicted from the kinetic scheme In Fig. 9.
|
|
Figure 9. Voltage dependence of transition rates. Rate constants were computed as described in Methods from single-channel activation time courses at â70 mV (n = 3 patches) and deactivation time courses at â100 (n = 2), â120 (n = 4), and â140 mV (n = 3). Superimposed on each plot is an exponential fit of the voltage dependence. The kinetic scheme (inset) summarizes the measurements from both activation and deactivation. Values for the rate constants (in sâ1) are given for V = â120 mV. The partial valence associated with each rate constant is given in parentheses.
|
|
Figure 10. SNS single-channel currents with K+, NH4+, or Rb+ as the permeant ions. (A) Single-channel currents recorded from inside-out patches, with 140 mM of the test ion in the pipette and 140 mM K+ in the bath. The voltage protocol is shown at the bottom. Note the small current in NH4+ at â60 mV, due to proximity to the reversal potential of â45 mV under these conditions. (B) Representative tail currents at â140 mV for each permeant ion. The open level is marked by an arrowhead. The S2â²â² and S3â²â² sublevels in Rb+ current are also indicated. (C) Amplitude histograms of tail currents at â140 mV for each permeant ion, accumulated from recordings filtered at 1 kHz. The data for K+ are the same as in Fig. 5 C; for NH4, the standard deviations of the fitted Gaussians are 0.1, 1.0, 0.9, and 1.1 pA for closed, sub1, sub2, and open levels, respectively. For Rb+, the standard deviations are 0.2 for the closed level, 0.6 for each sublevel, and 0.5 for the open level.
|
|
Figure 11. Solution switching experiment. (A) In an outside-âout patch, the channel is activated by a depolarization to â70 mV from the â100-mV holding potential. Switching of the external solution occurs during the tail current at â120 mV, as shown by the dotted lines. In traces 1, 2, and 4, the K+ â Rb+ switching occurs while the channel is at the open level; in traces 3 and 5, it occurs while the channel is at sub2 sublevel. Trace 4 shows Rb+ â K+ switching while the channel is at sub2. Trace 6 shows Rb+ â K+ switching while the channel is at sub1. The pipette solution contained 130 mM K-aspartate, 10 mM KCl, 1 mM EGTA, 10 mM Hepes, and the bath solution contained 140 mM K-aspartate, 1.8 mM CaCl2, 10 mM Hepes; each was adjusted to pH 7.3. (B) Scatter plot of mean current values obtained before and after solution switching. Mean current was calculated only from the traces in which the current levels were stable for at least 5 ms both before and after the solution switching.
|
|
Figure 12. Amplitudes of each current level in SNS channels at â120 mV when K+, NH4+, or Rb+ is the external ion.
|
|
Figure 13. Two speculative gating schemes. (A) The scheme of Zagotta et al. (1994b) is shown, in which a single subunit undergoes two voltage-dependent conformational transitions (inset) to reach a permissive state (circles). Subunit transitions occur independently, with the exception of a slowed transition from the open state 14 to state 13. The scheme has been modified to identify sublevels sub1 and sub2 with states in which two or three subunits are in the permissive state. (B) The scheme Is modified to include a distinct allosteric transition (dotted line) that follows activation of the subunits. The allosteric transition is assumed to be very rapid and switches between fully conducting and nonconducting states. Allosteric equilibria are influenced by a common factor θ that is greatly increased by the T442S mutation. In both schemes, the conducting states are represented by filled symbols.
|